2. Simultaneously, lift drum (#1) and cover (#3) from base (#2).
3. Remove cover (#3) from drum (#1).
4. Remove two pawls (#5) and two springs (#8) from drum (#1).
NOTE: TO PROCEED FURTHER, BASE (#2) MUST BE REMOVED FROM DECK OR MAST.
5. Remove two bearings (#7) from base (#2).
6. Inspect two pawls (#5) and springs (#6) on base Clean and oil. (Do not remove unless broken.)
7. Using a spiral motion, remove snap ring (#8) on bottom of base (#2).
8. Remove main shaft (#4) from base (#2).
9. Carefully wash pawls, springs, bearings, main shaft, base, and inside of drum.
10. Lightly grease inside of base (#2).
11. Assemble main shaft (#4) into base (#2).
12. Assemble snap ring (#8) onto bottom of base (#2), seating securely into groove on mainshaft (#4). (Use spiral motion.)
13. Grease two bearings (#7).
14. Assemble two bearings (#7) onto base (#2).
15. Assemble two pawls (#5) and two springs (#6) to drum (#1) noting correct pawl position as shown on exploded drawing.
16. Assemble drum (#1) onto base (#2).
17. Oil assembled pawls (#5) on drum (#1).
18. Rotate drum (#1) to check freedom of movement.
19. Assemble cover (#3) over top of drum (#1).
20. Assemble snap ring (#8) over cover (#3) seating securely into groove of main shaft (#4). (Use a spiral motion as when removed rather than shoving straight down.)
